Best Watchmaker Lathe-Mill For Sale near EVERGREEN AL

In general, for the watch maker, they offer the perfect installation. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a excellent lathe. That changed over the last few decades. A small business in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a lot more metal in it and allows for bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in EVERGREEN