Best Watchmaker Lathe-Mill For Sale near ESTILLFORK AL

In general, for the watchmaker near ESTILLFORK AL, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a quality lathe. That changed over the last few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.

Two upgrades in particular. First, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their normal spindle includes a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in ESTILLFORK