Best Watchmaker Lathe-Mill For Sale near EIGHT MILE AL

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. Let us talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a Swiss excellent lathe. That changed over the past few decades. A small company in Michigan called GlockCNC.com currently makes strategically done updates. Two upgrades specifically. First, they’ve made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings to the spindle.

For those in EIGHT MILE, AL They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in EIGHT MILE