Best Watchmaker Lathe-Mill For Sale near DELTA AL

In general, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That’s all changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle includes a OD and they shrink fit the bearings into the spindle.

For those in DELTA, AL They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout.