Best Watchmaker Lathe-Mill For Sale near DANNELLY AL

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be utilized. Let’s talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a Swiss quality lathe. That’s all changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings.

For those in DANNELLY, AL They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in DANNELLY