Best Watchmaker Lathe-Mill For Sale near DAMASCUS AL

In general, for the watchmaker near DAMASCUS AL, they offer the perfect installation. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the last few decades. A small business in Michigan known as GlockCNC.com currently makes strategically done updates.

Two upgrades specifically. To begin with, they’ve made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for bigger 62mm OD bearing. This, then, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece is not straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker lathe in DAMASCUS