Best Watchmaker Lathe-Mill For Sale near CORINTH AL

All in all, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This, then, allows for a larger spindle to be used. Let us talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That changed over the last few years. A small company in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their normal spindle has a OD and they shrink fit the bearings to the spindle.

For those in CORINTH, AL They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in CORINTH