Best Watchmaker Lathe-Mill For Sale near CONCORD AL
In general, for the watchmaker near CONCORD AL, they offer the perfect installation. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a quality lathe. That changed over the last few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their typical spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in CONCORD