Best Watchmaker Lathe-Mill For Sale near COMPASS BANK AL

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a excellent lathe. That’s all changed over the past few years. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. To begin with, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings to the spindle.

For those in COMPASS BANK, AL They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in COMPASS BANK