Best Watchmaker Lathe-Mill For Sale near CLEVELAND AL

In general, for the watchmaker near CLEVELAND AL, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades.

Two upgrades specifically. To begin with, they’ve made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has far more metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their typical spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in CLEVELAND