Best Watchmaker Lathe-Mill For Sale near CHATOM AL

In general, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine.

I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal in it and allows for bigger OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That changed over the last few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. First, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a OD and they shrink fit the bearings.

For those in CHATOM, AL They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in CHATOM