Best Watchmaker Lathe-Mill For Sale near CAMPBELL AL

In general, for the watchmaker near CAMPBELL AL, they offer the perfect setup. Plus, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That is all changed over the last few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades.

Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in CAMPBELL