Best Watchmaker Lathe-Mill For Sale near BURNWELL AL

In general, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That is all changed over the past few years. A small business in Michigan known as GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle includes a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in BURNWELL