Best Watchmaker Lathe-Mill For Sale near BROOKWOOD AL

All in all, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Why is this great news for the watchmaker and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be used. Let’s talk about those spindles for a watchmakers lathe.

Their typical spindle includes a OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in BROOKWOOD