Best Watchmaker Lathe-Mill For Sale near BLOSSBURG AL
In general, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a excellent lathe. That changed over the past few years. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.
Their typical spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in BLOSSBURG