Best Watchmaker Lathe-Mill For Sale near BHAM AL
In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.
I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a quality lathe. That changed over the past few years. A small company in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Why is this great news for the watchmakers and clockmakers? Their typical spindle includes a 30mm OD and they shrink fit the bearings.
For those in BHAM, AL They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in BHAM