Best Watchmaker Lathe-Mill For Sale near AUBURN UNIVERSITY AL
In general, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine.
I can’t foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss excellent lathe. That changed over the past few decades. A small business in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their spindle includes a 30mm OD and they shrink fit the bearings.
For those in AUBURN UNIVERSITY, AL They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece is not straight, then it will make it a challenge to dial out the runout.
Video: watchmaker lathe in AUBURN UNIVERSITY