Best Watchmaker Lathe-Mill For Sale near AUBURN UNIV AL
All in all, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a excellent lathe. That’s all changed over the past few years. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.
Their typical spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout.
Video: watchmaker mill in AUBURN UNIV