Best Watchmaker Lathe-Mill For Sale near ARMSTRONG AL

In general, for the watchmaker near ARMSTRONG AL, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a Swiss excellent lathe. That is all changed over the last few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done updates.

Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their spindle has a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.