Best Watchmaker Lathe-Mill For Sale near TOK AK

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.

I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for much bigger OD bearing. This, then, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a quality lathe. That is all changed over the last few years. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their normal spindle has a OD and they shrink fit the bearings into the spindle.

For those in TOK, AK They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in TOK