Best Watchmaker Lathe-Mill For Sale near SUTTON AK

All in all, for the watch maker, they offer the perfect installation. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That’s all changed over the past few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This, then, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their normal spindle includes a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in SUTTON