Best Watchmaker Lathe-Mill For Sale near STEVENS VLG AK

In general, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That is all changed over the past few decades. A small company in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades specifically. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has far more metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be used. Let’s talk about those spindles for a watchmakers lathe.

Their typical spindle has a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in STEVENS VLG