Best Watchmaker Lathe-Mill For Sale near SHAGELUK AK

In general, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That’s all changed over the past few years. A small company in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle.

For those in SHAGELUK, AK They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in SHAGELUK