Best Watchmaker Lathe-Mill For Sale near SCAMMON BAY AK

All in all, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That is all changed over the past few decades. A small business in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. First, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their normal spindle includes a 30mm OD and they shrink fit the bearings into the spindle.

For those in SCAMMON BAY, AK They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in SCAMMON BAY