Best Watchmaker Lathe-Mill For Sale near SAND POINT AK

All in all, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a Swiss quality lathe. That is all changed over the past few years. A small business in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their typical spindle has a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in SAND POINT