Best Watchmaker Lathe-Mill For Sale near SAINT MICHAEL AK
In general, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss quality lathe. That’s all changed over the past few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This, then, allows for a larger spindle to be used. Let us talk about these spindles for a watchmakers lathe.
Their normal spindle has a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in SAINT MICHAEL