Best Watchmaker Lathe-Mill For Sale near PRUDHOE BAY AK
In general, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a excellent lathe. That changed over the last few years. A small business in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their spindle has a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.