Best Watchmaker Lathe-Mill For Sale near PORT GRAHAM AK

In general, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal inside and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a quality lathe. That changed over the last few years. A small company in Michigan known as GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings.

For those in PORT GRAHAM, AK They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece isn’t straight, then it will make it a challenge to dial out the runout.

Video: watchmaker mill in PORT GRAHAM