Best Watchmaker Lathe-Mill For Sale near PLATINUM AK
All in all, for the watchmaker near PLATINUM AK, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a Swiss excellent lathe. That changed over the last few years. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades specifically. First, they have made there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal inside and allows for bigger 62mm OD bearing. This allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.
Their spindle has a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout.