Best Watchmaker Lathe-Mill For Sale near NIKISKI AK

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a Swiss quality lathe. That’s all changed over the last few years. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this great news for the watchmakers and clockmakers? Their typical spindle has a OD and they shrink fit the bearings into the spindle.

For those in NIKISKI, AK They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in NIKISKI