Best Watchmaker Lathe-Mill For Sale near NAPASKIAK AK
In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That changed over the past few decades. A small business in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Why is this great news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for bigger OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.
Their typical spindle has a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout.
Video: watchmaker mill in NAPASKIAK