Best Watchmaker Lathe-Mill For Sale near NAPAKIAK AK
In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That’s all changed over the last few decades. A small company in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.
Their spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece isn’t straight, then it will make it a challenge to dial out the runout.
Video: watchmaker lathe in NAPAKIAK