Best Watchmaker Lathe-Mill For Sale near KOBUK AK
In general, for the watchmaker near KOBUK AK, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a excellent lathe. That’s all changed over the past few years. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their typical spindle has a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout.
Video: watchmaker lathe in KOBUK