Best Watchmaker Lathe-Mill For Sale near KETCHIKAN AK
In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.
Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a excellent lathe. That is all changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their normal spindle has a OD and they shrink fit the bearings into the spindle.
For those in KETCHIKAN, AK They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in KETCHIKAN