Best Watchmaker Lathe-Mill For Sale near HAINES AK
All in all, for the watchmaker near HAINES AK, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a quality lathe. That is all changed over the last few years. A small company in Michigan known as GlockCNC.com now makes smartly done updates.
Two upgrades specifically. To begin with, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be used. Let us talk about these spindles for a watchmakers lathe.
Their normal spindle has a OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout.
Video: watchmaker lathe in HAINES