Best Watchmaker Lathe-Mill For Sale near EIELSON AFB AK
All in all, for the watchmaker near EIELSON AFB AK, they offer the perfect installation. Additionally, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That changed over the last few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.
Two upgrades specifically. First, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker mill in EIELSON AFB