Best Watchmaker Lathe-Mill For Sale near CIRCLE AK
All in all, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a quality lathe. That changed over the past few years. A small business in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be utilized. Let’s talk about these spindles for a watchmakers lathe.
Their typical spindle has a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in CIRCLE